It was a little difficult to actually hang the shelves . Instructions could use a little improvement

Love it! It was a little tricky to put up, but hubby figured it out.

It was a little awkward to put up, but it worked well, I didn’t measure it correctly so it almost didn’t go up, but my handy man was able to saw off 2 inches from one of the shelves so it fit perfectly on my wall. I’m so thankful! Can’t wait to dress it and put more stuff on it.

Absolutely love this shelf! Hardest part is putting it on the wall bc you need to measure pretty precise but easy to put together.

Love it! Hard for just one person to put together, but I knew that!

It looks like it has always been on the wall. It’s a very interes piece. My eyes are drawn to it when I enter the room.

Way too heavy . Had to return .

Extremely annoying to put together, hard to hold in place while attaching to the wall... But it looks good once it's up. Definitely bring in a friend to help.

It’s pretty large but holds a lot

Extremely frustrating to mount on wall. Hardware package included foam pieces to insert into the holes which, when pressed to the wall, would stick to the exact spot where the molly bolt/screw should be drilled. Unfortunately, this good idea didn't work because after pulling the sticker off of the foam marker, it was not very sticky and only one of them actually stuck to the wall. We tried again by putting some glue on the foam markers...didn't work. Had to use painters tape on the shelf edge where the hanging brackets were, transfer to the wall, level, and drill. Did this with each successive shelf but had to ensure that we held the whole unit up and leveled each of the smaller shelves which had some wiggle room to tilt in an uneven manner. Would have returned it but husband was persistent. Solution for company to improve product: Provide a large paper template with hole positions marked. Template could be taped to wall (after leveling) and the holes could be drilled at the exact locations needed. Wish we had created our own template....would have saved so much time! If you purchase this I would advise that you get a large piece of paper, assemble the unit and lay on floor with mounting hardware facing up, ensure all shelves are level, use marker to outline shelf lines (to help make template level) mark screw hole locations, tape template to wall after making sure it's level, and drill holes for wall anchors and screws. Good luck!